Use this Calibration Container to field calibrate your GPI Flow Meter.

GPI 5-Gallon Calibration Container

Calibration Container 5-Gallon


It is very important to verify meter accuracy and calibrate, as necessary, with an accurate calibration container. Meter calibration is critical for accurate fluid measurement. Variations in fluid characteristics, viscosity shift due to temperature changes, and varying flow rates can affect the accuracy. An accurate measurement container is important to facilitate the verification and calibration process. The GPI Calibration Container has been designed to provide an accurate, economical calibration measure. The blow-molded polyethylene construction makes it very strong and durable, yet lightweight.

Use the GPI Calibration Container with most noncommercial liquid flow meters. Follow the meter manufacturer's calibration instructions when field calibrating the meter. Each container is individually calibrated at the factory to an accuracy of +/- 0.5 percent. Accuracy may vary depending upon fluid and temperature at the time of use.

Before each use, make sure the container is clean and the scale-reading area is clear for best visibility of the fluid level. Place the container on a flat level surface. Fill to the 5-gallon or 20-litre marker on the scale. Allow for any foaming action that may occur.

GPI Calibration Container

NOTE: Varying lighting conditions may make it difficult to view the levels of certain liquids through the container material. If this occurs, position the container directly in front of a light source, such as a flashlight, to improve liquid level viewing. After filling the container with fluid to the zero mark, check the meter reading. The meter reading should match the dispensed units in the calibration container. Recalibrate the meter if the error margin between the meter reading and the container scale is not satisfactory. Clean the container thoroughly after each use to prevent any residue buildup and to maintain maximum accuracy. To clean, flush the container with water or the chemical manufacturer's suggested cleaning fluid and replace the container lid.

Warning: To avoid chemical exposure, follow chemical manufacturer's instructions for the disposal of contaminated water.

Price: $77.94
Buy Product Online | Visit Store Home
 
Manufactured by GPI


 Other Items from G2 Series Modules

  FM Approved Remote Kit Assembly - The Factory Mutual (FM) Approved Remote Kit Assembly Modifies all GPI Electronic Digital Meters for applications in specialized situations including remote indication and high or low fluid temperature metering applications.
  90 degree Adaptor Kit - GPI's new 90' Adaptor Kit allows for horizontal readouts on vertically mounted inline meters.
  External Power Module - Combining the External Power Module with Pulse Access Module and Industrial Grade Turbine allows the use of an external power source (7 to 30Vdc) that supplies voltage to the Computer Electronics.
  Pulse Access Module - Combining this Module with an Industrial Grade Turbine and Computer Electronics creates a low-cost flow sensor with both local readout and a pulse output which interfaces with various counters, controllers and compatible process equipment.
  Calibration Container 5-Gallon - Use this Calibration Container to field calibrate your GPI Flow Meter.
  FM Approved Sensor Kit - Designed for use with G2 Turbine Meters when pulse output is required and the meter is located with a hazardous location.
  GPI Electronic Programmer - GPI's Electronic Programmer was designed to allow end users the ability to customize and configure GPI Electronics to meet your specific needs using a laptop or desktop PC.
  4-20mA Module - Combine the 4-20mA Module with an Industrial Grade Turbine and Computer Electronics to provide an industry standard analog signal for connection to a wide variety of chart recorders, display equipment and process control equipment.
  Standard Remote Kit Assembly - The kit modifies GPI's Electronic Digital Meters for applications in specialized situations including remote indication and high or low fluid temperature metering applications.
  Conditioned Signal Output Module - Combine the Conditioned Signal Output Module with a GPI Turbine Kit to create a low-cost flow sensor with digital signal output which interfaces with various counters, controllers and compatible process equipment.

 

  Return To BuyGPI.com - Your GPI Turbine & Oval Gear Flow Meter Store

 

 

e-commerce software
E-commerce powered by MonsterCommerce shopping carts.